![]() That is, the interior of the case shouldn't be visible. I could be wrong, but my interpretation is that the cartridge needs look like the one in the OP. Bullets Machine made utilizing Full Length Gas Checks as to provide projectiles for the masses. ![]() Boolits as God laid it into the soil, Grand Old Galena, The Silver Stream graciously hand poured into molds for our consumption. "Ammunition with bullets recessed below the case mouth is not allowed." The place to discuss our favorite pb projectiles. It came to 57.5 every time, so I couldn't round it up to 5.8 or down to 5.7.Īlthough these have a whisker of lead above the case mouth, it seems they're pushing the limits of this rule from the Shooters Handbook (page 27). I made a flat bottomed seater plug with a tiny recess milled into the bottom for the ball sprue so there's no argument about it being seated below the case mouth.ĥ.75 grains sounds a bit fine maybe, but that's exactly what the RCBS Little Dandy rotor dropped with a 10 drop average. Extremely accurate in my 1858 conversion cylinder. Lyman 49 has load data for two different 55 grain cast bullets using Red Dot, 700X, Green Dot, Unique, AA 9, and several other powders. I found I don't even have to remove the slight bell, as they push easily into the chambers without having to smooth it out. Castboolits Gunloads Forum Full Length Of That fast a powder cannot maintain adiquate bore pressure for the full length of a rifle barrel to keep a jacketed bullet moving at low velocity. 454" cast round ball seated over 5.75 grains Bullseye in Schofield cases, a drop of Lee Liquid Alox around the edge for lube, and no crimp.
0 Comments
Leave a Reply. |